Processing Contents

Sheet Processing

• Cutting Machine

  This machine cuts sheet paper, nonwoven fabric, adhesive tape, film, etc. to any dimensions.
  It can cut anything from a few to a 1000 sheets in a single cut. Because the blade is fixed in a single position, work is conducted while moving the cutting side of the target material in the direction of the blade. Frequently, such machines have air blown from under the table to help the materials being cut move more smoothly.
  The dimensions are adjusted through moving the back gauge forwards and backwards.
  Since the cutting machine cannot handle rolls, it is only used with sheet materials.

• Drum Cutter

  This machine is used to make sheets (Flat paper) by cutting roll paper, non-woven fabric, adhesive tapes, films etc. after winding them multiple times into a drum shape.　It is also commonly known as Taiko.
  Depending on the characteristics and thickness of the material to be cut, the number of turns to be wound will vary, and although this machine can quickly process the roll into a sheet (flat size), there will be an error in the lengthwise dimension between the first and final turns. It is characterized by being overwhelmed.
  Basically, the drum cutter (Taiko) is a machine for cutting the length to a rough size, so it cannot be finished to a fine size. Therefore, the drum cutter (Tyco) is often paired with the cutting machine, and by processing the sheet (flat size) cut by the drum cutter (Tyco) side by side with the cutting machine, it is possible to finish it to fine dimensions. can be done.
  The cutting of wrapping paper etc. where rough measurement is allowed upon its usage can be processed by using only the drum cutter (Taiko) without using the cutting machine.

• Cutter

  This machine uses a rotary cutter (length) and slit blades (width) to cut roll paper, nonwoven fabric, adhesive tape, film, etc. according to the desired dimensions (sheet). Because multiple rolls can be worked, the feature of this machine is that extremely good work efficiency can be realized by adding more rolls.
  The multiple rolls of materials are cut together while being fed through the pass line (roller), and layers of cut sheet (flat paper) are accumulated as they pass over the belt.
  If only processing one or two rolls of paper that has little thickness or texture, the materials may not flow out along the belt following cutting by the rotary cutter; hence a certain number of rolls are required. If the materials being cut comprise only a few rolls of paper having little thickness or texture, they are often processed by means of drum cutter and cutting machine.

• Sheet Cutter

  This machine uses a rotary cutter (length) and slit blades (width) to cut roll paper, nonwoven fabric, adhesive tape, film, etc. according to the desired dimensions (sheet). This has structure similar to the cutter, however, usually only one roll can be worked and the machine itself is smaller in size.
  While the drum cutter and paper cutting machine can overlap and cut at the same time, the sheet cutter processes one sheet at a time, so the processing speed is slow, but there are cases where inspection is required during processing and scratches occur. It can be said that the sheet cutter is more suitable for things that are easy to cut.